Stockly.com Forums  

Go Back   Stockly.com Forums > Altair 8800 > Troubleshooting

Notices

Reply
 
Thread Tools Display Modes
  #1  
Old 05-26-2007, 04:19 AM
phe phe is offline
Member
 
Join Date: Dec 2006
Posts: 48
Default Power questions

I'm down to the final step, but I want to check my assumptions before I wire up the power supplies.

I'm planning to connect the black wire from the power cord to one of the "AC SW" terminals on the D/C board. Then I'll run a red wire from the other "AC SW" terminal to the L terminal on one power supply and then further on to the L terminal on the other power supply. I'll connect the white wire from the power coard to the N terminal on one power supply and then further on to the N terminal on the other power supply.

Is this correct?

Next questions:

The large power supply V+ terminal is +8vDC
The small power supply V+ terminal is +16vDC
The small power supply V- terminal is -16vDC

PAge 72 of the MITS manual says pins 1/51 are +5V, pin 2 is +15V, and pin 52 is -15V. I assume we are to use +8V, +16V, and -16V, correct?
Reply With Quote
  #2  
Old 05-26-2007, 11:54 PM
Grant Stockly Grant Stockly is offline
Administrator
 
Join Date: Jan 2005
Posts: 447
Default

Until you "trim" the power supplies they will be 7.5vDC and +/- 15vDC. On each power supply there is a pot to adjust the voltage. I found it runs fine on +7.5 and +15/-15. The vintage Altair used a linear power supply that when loaded down will have a dropping output voltage. The switching power supplies drive hard at 7.5v until overloaded.

On some of the vintage units the unloaded voltage of the +8v line was +12v to handle TONS of cards. This causes a problem when someone buys one of these units off of ebay (or any second hand place) and wants to test the system with only a CPU card and memory card. They over heat and go POOF. : )

The switching power supplies eliminate this worry. : )


The MITS manual says things like "+5v" because that is what the voltage will be after regulating... You might find a few different descriptions of the power lines in different places of the manual. Do you have close up pictures of how I wired my power supplies? In the manual?
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
High Voltage Power Supply Links Grant Stockly Electronics 0 12-15-2008 11:58 PM
Power Supply Upgrade Charles Troubleshooting 3 09-30-2008 08:54 PM
Updated power supply and the RTC card sje Altair 8800 7 11-10-2007 04:44 PM
AltairKit.com is online! Grant Stockly Announcements 10 11-28-2006 11:20 PM


All times are GMT. The time now is 01:51 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.