|
#1
|
|||
|
|||
Loading Basic
Hi Tom and All;
I am wondering What Baud Rate are you using , Tom ? The Last time I used to load up Basic, once I got the BUGGS worked out, I didn't have any trouble, I was sending at (If I remember right) 4800 Baud, with no character delays, but If it Helps I will have to try it.... You know that if you go back to Tape you will be STUCK at 300 Baud, Unless you use a different tape interface, like the Sudding tape system that went at 1100 Baud.... Or a Meca Alpha 1 that had higher tape rates, I don't know what the transfer rate was , But it loaded an operating system in seconds, If I remember right.... I hope someday to get it going again... Then of course there is Disk Systems.... Also I am Wondering What All you have as a system, what all is in it ? You can send me a private note if you like , rather than post out in the open... THANK YOU Marty |
#2
|
|||
|
|||
Quote:
Thanks for the reply. Tom L |
#3
|
|||
|
|||
Loading Basic
Hi Tom;
THANK YOU for your prompt reply !!!! I have a ComuPro Ram 16, but I have not had it working, But I have a Tanner 64K , with Selectable upper Ram Dis-able, and I can switch off at E000, E800, F000, or F800. and I can also switch for Phantom.... I had to Cut the Traces at pins 20 and 70 as they were tied to ground.... But other than that I like the Board and it has been no problem.... THANK YOU Marty |
#4
|
|||
|
|||
Hi Tom,
This is great news. How do you have the 2SIO board set up (which port is RS-232 and which is current loop? I'm assuming you load basic via RS-232 and then switch the system somehow so the teletype (current loop) becomes the console? How do you switch from one to the other? I never got this to work, but really would like to try it. Paul |
#5
|
|||
|
|||
Quote:
|
#6
|
|||
|
|||
Very good! Which converter did you buy? It seems they have several, so a recommendation would be most helpful.
An ACR cassette from Grant would immediately be on the top of my buy list. Paul |
#7
|
|||
|
|||
Quote:
http://www.bb-elec.com/tech_articles..._converter.asp Use Figure 7: 232CL9R Active Converter - Passive Device I also need a null modem adapter since the only 25 pin Male to 9 pin Male cable I can find requires it. If you wire your own cable, of course, you can eliminate the need for the null modem adapter. I have no connection with the company other then being a satisfied customer. Tom Lake Last edited by TomL_12953; 08-25-2009 at 12:28 PM. Reason: Added the note about not needing second 12v supply |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
BASIC Paper Tapes | TomL_12953 | Altair 8800 | 2 | 09-14-2009 08:37 AM |
Altair speaks Basic! | Pops Racer | Altair 8800 | 2 | 01-09-2009 03:24 PM |
Altair Disk Basic, How Do I return to the monitor program? | lovenewyawkcity | Altair 8800 | 1 | 09-05-2008 11:51 PM |
Basic | phe | Altair 8800 | 19 | 10-20-2007 11:05 PM |
Dazzler Board, Altair Basic or CP/M | lovenewyawkcity | Altair 8800 | 0 | 01-27-2007 01:11 AM |