|
|
#4
06-02-2008, 10:44 PM
|
|||
|
|||
One observation about the front panel: on pages 8 & 9 of Grant's instructions where he talks about placing nuts on the switches before installing the LEDs to get the correct front panel spacing, the photograph shows one nut on each switch but you really need two if you're going to use the little conical trim nuts after the panel is installed.
Geoff. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Front Panel LEDs and Other Issues | TomL_12953 | Troubleshooting | 4 | 08-20-2009 01:43 AM |
| Altair 680 Front Panel Programming? | lovenewyawkcity | Altair 680 | 1 | 10-06-2008 02:22 PM |
| Altair 680 front panel operation | sje | Altair 680 | 6 | 02-04-2008 05:33 AM |
| Kenbak-1 Front Panel Question | OCM | Kenbak-1 | 1 | 10-08-2007 08:15 PM |
| Kanbak front panel | Geoff Harrison | Kenbak-1 | 0 | 10-01-2007 09:33 PM |
Threaded Mode