Stockly.com Forums  

Go Back   Stockly.com Forums > Altair 8800 > Altair 8800

Notices

Reply
 
Thread Tools Display Modes
  #1  
Old 03-21-2008, 02:44 AM
Forbin376 Forbin376 is offline
Junior Member
 
Join Date: Jan 2008
Location: Oregon
Posts: 14
Send a message via Skype™ to Forbin376
Default 19,200 Baud from a 2SIO

Pin 3 of IC G can supply the correct clock for either (or both) of the 6850 Chips ICs D & E to operate at 19200 baud. I have inserted a 16-pin IC socket into the clock select pads labeled with the baud rates on the left and the CK0 and CK1 on the right. A short stiff wire, say an end clipped from a resistor, is used as a jumper to select the desired baud rates. I have added a wire from from Pin 3 of IC G to what would be pin 16 of this socket for the additional clock rate. For a more "permanent" selection use an IC Header installed into the socket with your baud rate selection(s) soldered onto it.
Reply With Quote
  #2  
Old 04-03-2008, 02:19 AM
Forbin376 Forbin376 is offline
Junior Member
 
Join Date: Jan 2008
Location: Oregon
Posts: 14
Send a message via Skype™ to Forbin376
Default Additional information (pictures)...

...is available here:

http://frankbarberis.tech.officelive.com/SerialBus.aspx

Frank
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
2SIO silkscreen error Geoff Harrison Altair 8800 7 07-29-2009 02:11 PM
Neat 2SIO trick Grant Stockly Altair 8800 1 11-27-2007 07:08 AM
Information on 2SIO Pops Racer Altair 8800 2 11-23-2007 06:36 PM


All times are GMT. The time now is 02:49 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.