|
#1
|
|||
|
|||
Problem Solved!!!
There was a manufacturing defect in the board and two traces were shorted. A bit of work with an exacto knife and I was able to remove the copper bridge between the traces. I've attached a jpeg of my handiwork. Now I have a finished Altair. Thanks for sticking with me guys to figure it out. (Gee --- all I have to show for this, from a demo perspective, is a switch that turns an LED on and off ) Paul Last edited by phe; 07-11-2007 at 05:52 AM. Reason: add attachment |
#2
|
|||
|
|||
Yep. Marty was right. I didn't understand the problem.
Oh well, at least his system is up and running! |
#3
|
|||
|
|||
protect circuit
Congratulations Paul !!!!!!
I am Glad that you found the problem and now have a working Board !!! Now you can get back to writing programs for you machine or watching the Led's blink !!! |
|
|