Stockly.com Forums  

Go Back   Stockly.com Forums > Altair 8800 > Troubleshooting

Notices

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 05-26-2007, 03:19 AM
phe phe is offline
Member
 
Join Date: Dec 2006
Posts: 48
Default Power questions

I'm down to the final step, but I want to check my assumptions before I wire up the power supplies.

I'm planning to connect the black wire from the power cord to one of the "AC SW" terminals on the D/C board. Then I'll run a red wire from the other "AC SW" terminal to the L terminal on one power supply and then further on to the L terminal on the other power supply. I'll connect the white wire from the power coard to the N terminal on one power supply and then further on to the N terminal on the other power supply.

Is this correct?

Next questions:

The large power supply V+ terminal is +8vDC
The small power supply V+ terminal is +16vDC
The small power supply V- terminal is -16vDC

PAge 72 of the MITS manual says pins 1/51 are +5V, pin 2 is +15V, and pin 52 is -15V. I assume we are to use +8V, +16V, and -16V, correct?
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
High Voltage Power Supply Links Grant Stockly Electronics 0 12-15-2008 10:58 PM
Power Supply Upgrade Charles Troubleshooting 3 09-30-2008 07:54 PM
Updated power supply and the RTC card sje Altair 8800 7 11-10-2007 03:44 PM
AltairKit.com is online! Grant Stockly Announcements 10 11-28-2006 10:20 PM


All times are GMT. The time now is 04:56 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.