|
#1
|
|||
|
|||
Outstanding. Thanks, Tom. You know... I'm still going to try to get my current loops setup working. Now that we know the problem may have been the diodes, I can fix that and try again.
Tom, how far did you get? I suppose you set the 2SIO board to address 20. You mentioned that you put the teletype on port 1. So that means the PC was on port 0? Which order did you have these two? Then, did you (would you) have to do anything for basic to recognize the teletype on port 1 and use it as the console? How does basic know that the "console" is now at address 22? Paul |
#2
|
|||
|
|||
Re: Loading BASIC With Tera Term
Oops! There's a difference in terminology here! I sometimes refer to the two ports on the 2SIO as Port 1 and Port 2 rather than Port 0 and Port 1 so my Port 1 would be your Port 0! OK, so I'm inconsistent. This means that I didn't have to change BASIC to access other than its default port. I have been helped so much on this and other forums (fora?) that I'm glad to offer any help I can back to the Altair community. My experience is being gained by trial-and-error (a LOT of trial and even more error!) so feel free to ask me for any help you might need. If I don't know the answer, I'll cheerfully make one up
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
BASIC Paper Tapes | TomL_12953 | Altair 8800 | 2 | 09-14-2009 08:37 AM |
Altair speaks Basic! | Pops Racer | Altair 8800 | 2 | 01-09-2009 03:24 PM |
Altair Disk Basic, How Do I return to the monitor program? | lovenewyawkcity | Altair 8800 | 1 | 09-05-2008 11:51 PM |
Basic | phe | Altair 8800 | 19 | 10-20-2007 11:05 PM |
Dazzler Board, Altair Basic or CP/M | lovenewyawkcity | Altair 8800 | 0 | 01-27-2007 01:11 AM |