|
#1
|
|||
|
|||
2 sio
Hi Geoff;
It does the same thing at 300 baud... here is was is shown on the screen: ( bit set to 7) >"TIU*)*(S W%E black square )H!UP'TJ black square [ with line in middle ( changed to 8 bits) WANT SI two parrellel bars ? black square ( used capital answers) WANt SI two parrellel bars ? N WANT RN-? N WANT SQ pii ? N 58317 BYTES FRE a large + sign [4K VERSION black rectangle 0 pii with line on top of it (if it is in lower case letter i have attempted to describe what is there.) ( or told what I did) THANK YOU Marty |
#2
|
|||
|
|||
Quote:
Geoff. |
#3
|
|||
|
|||
2 sio
Hi Geoff;
THANK YOU, THANK YOU !! I didn't remember reading that on the paper about boot loaders and Basic, I must have missed that part ... Also, I think that putting in the wires from pins 23 and 24 to ground was/ is a BIG part of solving the problem, before that it would only work in echo mode. THANK YOU Marty |
#4
|
|||
|
|||
2 sio
hi Geoff;
That took care of the problem ... THANK YOU Marty |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
88-2 Sio | benalford | Altair 8800 | 2 | 08-28-2009 09:59 AM |