#1
|
|||
|
|||
Microscope examination of a PLD
Article: 77917
Subject: Microscope examination of a PLD From: "logjam" <grant@cmosxray.com> Date: 22 Jan 2005 02:13:56 -0800 Links: << >> << T >> << A >> I'm probably going to attempt a distructive test on a PLD to determine its function. I'm wondering if anyone has tried this, and with what success? I found this: "An important architectural feature that is found on virtually all PLDs is not shown on logic diagrams. This feature is the security fuse. Normally, the fuse pattern programmed into a PLD can, like a PROM, be read and displayed or copied by programming hardware. Devices with a security fuse, however, provide the ability to disable this read function. This allows the design to be somewhat secure from attempts to copy or reverse engineer it. In reality, it's relatively easy to shave the top off of a bipolar PLD and examine the programmed fuses with a microscope. For bipolar PLDs, then, would be copiers are merely inconvenienced. Erasable CMOS PLDs are considerably more secure, since it's very difficult, if not impossible, to determine their function from examination." From http://www.ee.cooper.edu/courses/cou...es/EE151/PLD1/ Anyone here ever "shave" a chip for examination? I have access to a video microscope at the university. I also have a DV camcorder with DV in, so I could take the pictures, post them, and then beg for more help. Any suggestions? I would be shaving the top off of some 16R8/4 chips. Would heating them to around 250-300F for a while help? Shaving the tops down while hot? I eventually want to rewrite all of the equations for speed, but getting a 100% copy of the OEM work was the goal. Grant |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
QX5 microscope | tonigau | Electronics | 0 | 02-05-2006 05:09 PM |
Reading a PAL16R8 with a microscope | Grant Stockly | Electronics | 3 | 09-17-2005 04:55 PM |