|
#1
|
|||
|
|||
card guide...
Something like the attached image perhaps?
g. |
#2
|
|||
|
|||
Card Guide
It would have to have a piece perpendicular to the guide with space for two screws to fasten it to the motherboard. Unlike PC card guides these don't fasten to the case but rather to the motherboard.
|
#3
|
|||
|
|||
Tom, could you point me to a picture or a drawing of what the correct part looks like? The image I included was just a ballpark guess as to what you guys would be after. It's been 25 years since I actually looked at the insides of an S-100 box in person.
g. |
#4
|
|||
|
|||
Here are a couple of pictures of what the card guide looks like.
|
#5
|
|||
|
|||
Thanks Mardy!
Can you tell me how wide and deep the slot is, how high the "tower" is and how wide the foot is? I also need to know the hole spacing on the bottom. I can make something that will do the job but it will NOT look just like that. It would however be mechanically identical. g. |
#6
|
|||
|
|||
I'm in the process of creating a 3-D mechanical drawing of the original card guide. When it is completed, I will post the DXF file.
Anybody out there have the resources to make a mold? -Mardy |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Adjusting or Tuning the Altair CPU Card | Grant Stockly | Troubleshooting | 1 | 05-01-2008 06:07 PM |
SuperAltair Card Development | Grant Stockly | Altair 8800 | 3 | 03-02-2008 04:04 PM |
"tuning" the altair CPU card? | Cappellanus | Troubleshooting | 6 | 11-19-2007 12:34 PM |
Updated power supply and the RTC card | sje | Altair 8800 | 7 | 11-10-2007 03:44 PM |
card guides | frotz | Altair 8800 | 1 | 10-05-2007 04:05 AM |