View Single Post
  #14  
Old 07-11-2007, 05:47 AM
phe phe is offline
Member
 
Join Date: Dec 2006
Posts: 48
Default

Problem Solved!!!

There was a manufacturing defect in the board and two traces were shorted. A bit of work with an exacto knife and I was able to remove the copper bridge between the traces. I've attached a jpeg of my handiwork.

Now I have a finished Altair. Thanks for sticking with me guys to figure it out.

(Gee --- all I have to show for this, from a demo perspective, is a switch that turns an LED on and off )

Paul
Attached Images
 

Last edited by phe; 07-11-2007 at 05:52 AM. Reason: add attachment
Reply With Quote