Thread: Up and Running
View Single Post
  #14  
Old 06-19-2008, 02:16 AM
bugman bugman is offline
Member
 
Join Date: Nov 2007
Posts: 30
Default

All that effort and I'm almost embarrased to say what the solution was. The socket into the motherboard from the mini 32k wasn't seated enough. The trouble is that you can't see the pins make contact very well because there is almost no clearance (Grant says this in the instructions). But, I had to use way more force to get a good seating than I'm usually comfortable with. Advice to anyone else, install the mini-expansion with the motherboard on a flat surface outside of the case.

What do they say? The obvious answer is usually the correct one?

The front panel and the terminal seem to be working perfectly.

Thanks Geoff, you led me in the direction of the CPU, which was the correct focus area.
Reply With Quote