View Single Post
Old 10-13-2007, 11:42 PM
Geoff Harrison Geoff Harrison is offline
Senior Member
Join Date: Feb 2007
Posts: 104

Originally Posted by Grant Stockly View Post
You may notice some differences between the assembled code and Geoff's hand code. John used the condition "Zero" when "Unconditional" was specified. Geoff used "Positive Non-Zero", but this difference should not affect the operation of the code. My kenbak is still in pieces from scanning the motherboard. Geoff, can you key in this version of the cylon program and see if it works?
Yep, it works fine.

The only reason I used Positive Non-Zero on the unconditional jump was because the last 3 bits of the instruction must not be less than 003, so I just set them to 007. Any value 003 or greater will work.
Reply With Quote