Quote:
Originally Posted by phe
Tom, how far did you get? I suppose you set the 2SIO board to address 20. You mentioned that you put the teletype on port 1. So that means the PC was on port 0? Which order did you have these two?
Paul
|
Oops! There's a difference in terminology here! I sometimes refer to the two ports on the 2SIO as Port 1 and Port 2 rather than Port 0 and Port 1 so my Port 1 would be your Port 0! OK, so I'm inconsistent. This means that I didn't have to change BASIC to access other than its default port. I have been helped so much on this and other forums (fora?) that I'm glad to offer any help I can back to the Altair community. My experience is being gained by trial-and-error (a LOT of trial and even more error!) so feel free to ask me for any help you might need. If I don't know the answer, I'll cheerfully make one up
