Quote:
Originally Posted by phe
Thanks. I see now what needs to be done. Page 14 of the altair guide is very important because it tell you things like the number of the unlabled pad. I wish I had followed the altair direction and soldering in all the wired with long lenghts and taped labels on the other end as it would have been easier.
|
I did it one wire at a time with the boards bolted into the unit. Cut them to length as I went. I didn't find this too hard. How are you doing it?
Quote:
Originally Posted by phe
One suggestion for future kit assemblers: get a pad of paper and list the hold number top to bottom along the side and left to right along the top. That would make it a lot easier.
|
I could provide a 1:1 scale image like what you describe in the manual too. Or as an insert that people can cut out.
Would it help you RIGHT now to have that? I hope its not too late!
See the zip file below for a 300 dpi image of the back of the board with the silkscreen numbering for the wire holes in the image. I hope it helps!
Feel free to request ANYTHING that will help you out...
http://www.altairkit.com/manuals/Sup..._Guide_001.zip
At least download it and let me know if it WOULD have helped if you're done.
If you don't have a printer big enough you can clip the image into two pieces and print each piece.