Thread: Basic
View Single Post
  #16  
Old 10-15-2007, 06:27 AM
Grant Stockly Grant Stockly is offline
Administrator
 
Join Date: Jan 2005
Posts: 447
Default

Quote:
Originally Posted by phe View Post
Rather than resetting my card to 4800, I've tried the intercharacter delay. I even tried 100ms, which makes the transmit rate very slow. I cannot tell if Basic is loaded into memory or not, all I can confirm is that I cannot get anything to display and that the low memory locations do indeed get changed.

A quick glance at the loader helps me see how it is set for 020/021. I'll use this to try to debug what is going on. Unfortunately I have to head out of town tomorrow for two weeks. What lousy timing!
Did you see ANY blinking in the lights in any of the tests? Your card is set for port 020/021, right? Not like the one in the picture I sent you? I had mine setup for CP/M which required the 2SIO be at port 0/1.

Did you have both the 4k and 1k memory card installed? Did you change the jumper setting on the 1k memory card? For the initial tests don't have the 1k memory card installed.
Reply With Quote