View Single Post
  #5  
Old 06-10-2008, 07:12 PM
TomL_12953 TomL_12953 is offline
Member
 
Join Date: Jan 2007
Location: Malone, NY USA
Posts: 80
Send a message via AIM to TomL_12953 Send a message via MSN to TomL_12953 Send a message via Yahoo to TomL_12953 Send a message via Skype™ to TomL_12953
Default

Quote:
Originally Posted by Forbin376 View Post
Oh what has been lost: Once upon a time I had a Mylar paper tape of the MITS 12K BASIC Version 3.2 that was loaded into my Altair 8800 A by an ASR-33 Teletype and a MITS 2SIO board!
Do you remember if you had to load a small program BEFORE the loader to set your 2SIO to 8-N-2 rather than the 7-E-2 that the Teletype needs and then run another AFTER BASIC is loaded to put it back to 7-E-2? The MITS BASIC manual doesn't say it's necessary but the bootloader site says it is and it makes sense that it would be.
Reply With Quote