Thread: Power questions
View Single Post
  #1  
Old 05-26-2007, 03:19 AM
phe phe is offline
Member
 
Join Date: Dec 2006
Posts: 48
Default Power questions

I'm down to the final step, but I want to check my assumptions before I wire up the power supplies.

I'm planning to connect the black wire from the power cord to one of the "AC SW" terminals on the D/C board. Then I'll run a red wire from the other "AC SW" terminal to the L terminal on one power supply and then further on to the L terminal on the other power supply. I'll connect the white wire from the power coard to the N terminal on one power supply and then further on to the N terminal on the other power supply.

Is this correct?

Next questions:

The large power supply V+ terminal is +8vDC
The small power supply V+ terminal is +16vDC
The small power supply V- terminal is -16vDC

PAge 72 of the MITS manual says pins 1/51 are +5V, pin 2 is +15V, and pin 52 is -15V. I assume we are to use +8V, +16V, and -16V, correct?
Reply With Quote